Heat Pump Installation in Pearland, TX
A new system here will heat from December through February and cool from April through October every year. Tell us about the house, and a licensed contractor who covers Brazoria County will get in touch.
Tell us about the job
It takes about a minute.
Pearland runs its heat pump nearly all year
Cooling season here stretches from April through October, seven months of afternoons averaging 91°F. Winter is short, just December through February, and even then nights average 47°F. That leaves a heat pump doing something almost every month of the year, with cooling as the harder, longer job.
A new split-system heat pump installed here has to meet federal minimums of 14.3 SEER2 for cooling and 7.5 HSPF2 for heating. Nearly half of homes in this area heat with electricity, and Texas saw a third of households lose power for at least a day in 2024. Wind is the bigger risk here too, with 63 damaging wind events recorded over the last ten years against a single winter storm.
- 3 months
- December through February, your system heats
- 7 months
- April through October, it cools
- 47°F
- the average winter night it heats against
- 91°F
- the average summer afternoon it cools against

NOAA nClimDiv, 1991–2020 normals
Texas requires HVAC contractors to hold a state license.
The Texas Department of Licensing and Regulation tests contractors before it licenses them, and that license belongs to the contractor, not to any single job. So the state's record is on the person or company, not on this particular heat pump install.
For the install itself, the protection you're looking for comes from the local building office. In most cities and counties in Brazoria County, putting in a heat pump needs a permit and an inspection once the work is done, and that inspection is what checks the job itself rather than the contractor's history.
Source: Texas Department of Licensing and Regulation
- Is a heat pump better than a furnace?
- A heat pump does something a furnace cannot. It moves heat instead of burning fuel to make it, and it also cools your home in summer, so one system covers both jobs. Pearland only sees winter lows around 47°F, mild enough that a heat pump can carry the heating load without much strain. A furnace only heats, so you would still need a separate air conditioner for the 7 months a year this area needs cooling.
- What's the difference between a heat pump and an air conditioner?
- An air conditioner only cools. A heat pump does the same cooling job in summer, but it can also run in reverse and pull heat into your home in winter. Inside, the two work almost the same way, with a compressor and refrigerant moving heat from one place to another. The difference is that a heat pump has a reversing valve, so it is not locked into cooling only.
- Does a heat pump work in cold weather?
- Yes, and in Pearland the winters stay easy on it. Heat pumps pull heat from outside air even when it feels cold, and they lose efficiency only once temperatures drop well below what this area sees. Winter nights here average 47°F, which is comfortably within the range a heat pump handles without help from backup heat. Homes only need heat here from December through February, so a heat pump is covering a short, mild season, not a long, harsh one.

