HVAC Installation in Pearland, TX
A new system here will heat from December through February and cool from April through October every year. Tell us about the house, and a licensed contractor who covers Brazoria County will get in touch.
Tell us about the job
It takes about a minute.
Ten months of the year, your system is working
Pearland only gets three months of real winter, and even then nights average 47°F. Cooling is the bigger job here, running April through October, seven months, with summer afternoons averaging 91°F. That's ten months a year your heating and cooling system is on, which asks a lot of the equipment and means a new system should be sized to handle that cooling load without struggling.
Nearly half of homes here heat with electricity, so when a storm knocks out power, heat goes with it. Wind is the main risk in this area, not winter storms, and a third of Texas households lost power for at least 24 hours in 2024. Whatever system you install, it's worth planning for what happens when the power drops.
- 3 months
- December through February, your system heats
- 7 months
- April through October, it cools
- 47°F
- the average winter night it heats against
- 91°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Texas requires HVAC contractors to hold a state license.
The Texas Department of Licensing and Regulation tests contractors before it licenses them and keeps a record of who holds one. That license belongs to the contractor, not to any single job, so the same license that covers a repair down the street covers a full system installation at your house.
For an installation, the license is what stands behind the person doing the work, but it is not the only check on this job. In most cities and counties, replacing a heating and cooling system needs a permit from the local building office, and the work gets inspected once it is done. That inspection is what catches a bad connection or a system put in wrong, separate from whatever the license already tells you about the contractor.
Source: Texas Department of Licensing and Regulation
- When should I replace my HVAC system?
- Once your system needs repairs more than once a year, or a repair quote starts approaching what a new system would run, replacing it usually makes more sense than continuing to fix it. Watch for signs like uneven temperatures room to room, or a furnace that runs long stretches without warming the house. Here, your air conditioner runs from April through October, so a unit that struggles to keep up is going to keep struggling every one of those months until it's replaced. A contractor can look at the age and condition of your system and tell you honestly whether it is worth repairing again.
- Should I replace my furnace and air conditioner at the same time?
- If both are close in age, yes, it usually makes sense to replace them together. A furnace and air conditioner installed at the same time are matched to work with each other, and pairing an old furnace with a new air conditioner, or the other way around, can mean the new part never runs at its best. Winters here only run December through February while cooling runs April through October, so the furnace does far less work over the year than the air conditioner, and that shows up as different wear on each one. A contractor can look at the age and condition of both and tell you honestly whether one or both need to go.
- What happens during an HVAC installation?
- A contractor first removes the old furnace, air conditioner, or both, along with the old refrigerant lines and any parts that won't be reused. The new equipment gets set in place, the ductwork or refrigerant lines are connected, and the electrical and gas or fuel connections are made. Once everything is hooked up, the system gets run through a full heating and cooling cycle to check airflow, temperature, and that it shuts off and restarts properly. The last step is usually going over the thermostat settings and any warranty paperwork with you.