HVAC Installation in Beaumont, TX
A new system here will heat from November through March and cool from April through October every year. Tell us about the house, and a licensed contractor who covers Jefferson County will get in touch.
Tell us about the job
It takes about a minute.
Beaumont asks for a system that can run almost year round
Cooling season here runs April through October, seven months of afternoons averaging 91°F. Winter is shorter, November through March, with nights averaging 46°F. That leaves almost no month where a new system gets to sit idle. The compressor and the heat exchanger both see real work most of the year.
58.8% of homes here heat with electricity, so a furnace or heat pump's wiring and controls matter as much as the burner or the coil. And with 33% of Texas households losing power for a day or more in 2024, and 48 damaging wind events recorded here over the past ten years, it's worth asking a contractor how the system you choose comes back on after the power drops.
- 5 months
- November through March, your system heats
- 7 months
- April through October, it cools
- 46°F
- the average winter night it heats against
- 91°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Texas requires HVAC contractors to hold a state license.
The Texas Department of Licensing and Regulation tests and licenses HVAC contractors before they can legally take on a job like this. The license is tied to the contractor, not to the specific job, so it stands behind everything they install, not just this one system.
For an installation, that license is the thing accountable for the work, but it is not the only check on this job. In most cities and counties, replacing a heating and cooling system needs a permit from the local building office, with an inspection once the work is finished. That inspection is separate from the state license and looks at the installation itself, not the contractor's record.
Source: Texas Department of Licensing and Regulation
- When should I replace my HVAC system?
- Replace it when repairs start happening every year or the unit can't keep up on the hottest afternoons or coldest nights. A system nearing the end of its life shows this pattern before it fails outright, and that's the point to stop repairing and start planning a replacement instead. Summer afternoons here average 91°F, and homes need cooling from April through October, so a unit that's already struggling in spring usually won't make it through a full summer. If a contractor tells you the same part is failing again, take that as the sign.
- Should I replace my furnace and air conditioner at the same time?
- If they're close in age, yes. A furnace and air conditioner installed together are matched to work as one system, and pairing an old unit with a new one can mean the new one never runs at its rated efficiency. Homes here need heat from November through March and cooling from April through October, so both sides of the system see real use every year. If your furnace and AC were installed around the same time and one is failing, the other is likely not far behind.
- What happens during an HVAC installation?
- A contractor removes the old equipment, then sets the new furnace, air conditioner, or both, and connects them to your existing ductwork, gas line, and electrical. They check the ducts for leaks or sizing problems, since a new system connected to bad ductwork won't perform right no matter how good the equipment is. Refrigerant lines get connected and tested, and the system gets fired up and checked for proper airflow and temperature. In Texas, the contractor doing this work has to hold a state license issued by the Texas Department of Licensing and Regulation, so ask to see it before work starts.