Water Heater Repair in Killeen, TX
Tell us what your water heater is doing, and a licensed contractor who covers Bell County will get in touch.
Tell us about the job
It takes about a minute.
What Bell County does to your water heater
Killeen gets real winter, five months of it from November through March, with nights averaging 39°F. Your water heater works harder through those months, and the tank, the burner or the heating element, and the thermostat all feel it.
Power is the bigger risk here. Across Texas, a third of households lost power for a full day or more in 2024, and Bell County has logged four winter storms and 44 damaging wind events over the past ten years. A gas water heater with a standing pilot keeps working through an outage. One with electronic ignition won't, and when the power comes back, some units need to be relit or reset by hand before you get hot water again.
- 39°F
- the average winter night, and colder incoming water means longer heating
- 5 months
- November through March, the months homes here need heat
- 33%
- of Texas households lost power for a day or more in 2024, and a heater with an electric element or electric ignition stops without it

NOAA nClimDiv, 1991–2020 normals
A new water heater would cut about $290 a year off hot water for a typical Texas home.
Estimates for a typical Texas home, compared with an older unit built to the federal minimum, from EIA household energy data and Texas fuel prices. Your home will differ.
Repair makes sense when an element, thermostat or gas valve has failed.
Replacement makes sense when the tank itself is leaking.
- Why is my water heater leaking from the bottom?
- Most of the time this means the tank itself has rusted through, and once that happens the tank can't be patched or sealed. It could also be a loose drain valve or a fitting that's just weeping, which a contractor can tighten or replace. But water pooling under the tank, as opposed to dripping from a pipe above it, usually points to the tank failing from the inside. If that's the case, the water heater needs to be replaced, not repaired.
- Why won't the pilot light on my water heater stay lit?
- The most common cause is a worn thermocouple, the small sensor that tells the gas valve the pilot is burning. When it wears out, it can't sense the flame properly and the gas valve shuts off as a safety measure. A dirty pilot orifice or a draft blowing out the flame can also cause this. A contractor can test the thermocouple and replace it if that's the problem.
- Can a tankless water heater be repaired?
- Yes, most problems with a tankless water heater can be repaired without replacing the whole unit. Common repairs include descaling the heat exchanger, replacing an igniter, or clearing a blocked vent. Because these units run on electronics and sensors, a contractor needs to run a diagnostic to find out which part is causing the issue before repairing it.


