HVAC Installation in El Paso, TX
A new system here will heat from November through March and cool from May through September every year. Tell us about the house, and a licensed contractor who covers El Paso County will get in touch.
Tell us about the job
It takes about a minute.
El Paso asks for both a working furnace and a working AC
Summer afternoons here average 95°F, and a new system has to carry that load for five months, May through September. Winter is shorter but real. Nights average 32°F from December through February, right at freezing, and the heat runs from November through March.
That's 10 months a year when the system is doing one job or the other. Most homes here heat with gas, and whatever furnace goes in has to meet the federal minimum efficiency rating. On the storm side, the region has seen 5 winter storms and 70 damaging wind events over the past ten years, and across Texas a third of households lost power for at least 24 hours in 2024. A system that can't restart on its own once power comes back means a cold house or a hot one until someone resets it.
- 5 months
- November through March, your system heats
- 5 months
- May through September, it cools
- 32°F
- the average winter night it heats against
- 95°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Texas requires HVAC contractors to hold a state license.
The Texas Department of Licensing and Regulation issues that license, and it tests the contractor, not the crew on your roof or the paperwork for your specific job. Once a contractor holds it, the license covers them as a contractor, not this installation on its own.
For a job like this, the license tells you the contractor met the state's bar to do the work at all. The permit is separate from that. In most cities and counties, putting in a new furnace, air conditioner or heat pump needs a permit from the local building office, with an inspection once the work is done. The license says who is allowed to do the job. The permit and inspection are what check this particular installation.
Source: Texas Department of Licensing and Regulation
- When should I replace my HVAC system?
- Replace it when repairs stop making sense or when it can no longer keep up on the hottest afternoons or coldest nights. A furnace or AC that needs a second or third repair call in a year is usually past the point of throwing more money at it. Watch for rooms that never get comfortable, a system that runs constantly through the summer, or a furnace that struggles on the coldest nights from November through March. If a contractor tells you a repair costs a large share of what a new system would, that is a sign to stop repairing and start planning a replacement.
- Should I replace my furnace and air conditioner at the same time?
- If they are close in age, yes, it usually makes sense to replace them together. A furnace and AC installed at the same time tend to wear out around the same time, so if one is failing, the other is often not far behind. They also share the blower and ductwork, so matching them lets a contractor size the whole system correctly instead of pairing new equipment with an old, mismatched unit. If your furnace and AC are different ages, or one was already replaced more recently, a contractor can look at both and tell you whether replacing just one still makes sense for your home.
- What happens during an HVAC installation?
- A contractor removes the old equipment, sets the new furnace and or air conditioner in place, and connects it to your existing ductwork, gas line, electrical, and refrigerant lines. They check the ductwork for leaks or damage while it is open, since a new system pushing air through bad ducts will not perform the way it should. Once everything is connected, they test the system, check refrigerant charge and airflow, and confirm it cycles on and off correctly before they leave. The exact steps depend on what you are replacing and how your home is set up, so a contractor walking your house can tell you what your installation will involve.